How To Cut Laminate: Complete Guide

It is not easy to complete deep cuts in laminate flooring. Compared to conventional wood floors, laminate is more robust and harder to separate. It requires high technical skills as well as sharpness from specialized cutting tools. So what do we need?

In this post, The King Live will detail how to cut laminate. It will fully cover how to prepare tools and perform. Let's read together!

How To Cut Laminate: A Comprehensive Guide

This quick guide covers all the laminate floor cuts you need to make. However, read them carefully because just one detail is wrong, forcing you to start from scratch.

Preparing instruments

Laminate is made from synthetic materials with a certain hardness. To ensure the successful contouring of the cuts, we need to prepare the following tools:

• Professional square ruler for carpenter: It is used for more precise angle alignment to create unique technical shapes
• Roll tape measure: This type of ruler is used to measure the length and width of a piece of wood and conduct a quick and complete cut.
• Pencil for marking: The more precise the pen, the sharper the cut will be.
• Circular saw machine: Circular saw is a device many people choose to cut laminate. Alternatively, consider using an angle or table saw if that's right for your project.
• Belt grinder: You need a specialized hero to make the edge of the wood after cutting and proceed quickly.
• Jigsaw: This is an essential tool for cutting wooden floors, used for creating oddly shaped cuts to match columns, pipes, and some other obstacles.
• Profile ruler: Used for constructions with lots of strangely shaped obstacles.

Here are some of the essential tools for my simple cutting tutorial below. For other methods, additional tools will be required.

Cutting Laminate

laminate to length

To Cutting Laminate length, you need to follow these steps strictly:

• Measure the required length with your tape measure
• Use a marker to mark the cut
• Use a square ruler and pencil to create a straight line on the board
• Continue using your cutter to cut the excess of the line, and use a soft, damp cloth to remove any remaining ink.

Cut laminate to the width

Cut laminate to width so it can be installed easily in front of obstacles, such as walls, cabinets, or fireplaces. Note that this type of laminate flooring requires an expansion space of about ¼ inch to ensure that the floor does not warp when it swells due to moisture. Regarding the steps, specifically as follows:

• Using a tape measure to measure the width, the laminate surface should be cut more comprehensively than the actual measured parameters to avoid the warping phenomenon mentioned earlier.
• Place a wooden board over the counter area, then use a pen to record the measured width.
• Make another cut through this mark and adjust for the exact laminate surface that fits your intended use.

Cutting wood around pipes and other obstacles

Cutting laminate for construction with complex obstacles, typically around pipes, is a big challenge for operators. To successfully contour each cut, you can refer to the steps below:

First, measure the length and width to the center of the pipe.

• Use a clear marker on the laminate.
• Use a hole saw about ½ inch larger than the pipe diameter to make the correct hole for the tube.
• Fit the pieces around the tube and use special glue to stick the pieces together.

In that case are obstacles of complex shapes. The steps are as follows:

• Use the profile ruler to copy the form of the block.
• Place the profile ruler on the piece of plywood and trace what appears on it with a pen.
• Use a jigsaw to make a preliminary cut and cut the excess side of the board.

Find More Information:

Learn How To Cut Laminate At Home

How To Cut Laminate For Your Flooring Or Countertop

Conclusion

The above instructions on how to cut laminate are the simplest for you. It does not require too much care but still ensures the accuracy of each of your cuts. But not so that you are subjective because that can damage your laminate.

Give it a try, and come back soon to give me feedback!

Thank you for reading!